![]() ![]() Due to the elastic nature of the metal in crimped connections, they are highly resistant to vibration and thermal shock. A key idea behind crimped connectors is that the finished connection should be gas-tight.Įffective crimp connections deform the metal of the connector past its yield point so that the compressed wire causes tension in the surrounding connector, and these forces counter each other to create a high degree of static friction which holds the cable in place. The crimping is usually accomplished with special crimping tool such as crimping pliers. Theory Ĭrimp-on connectors are attached by inserting the stripped end of a stranded wire into a portion of the connector, which is then mechanically deformed by compressing ( crimping) it tightly around the wire. ![]() In 2010, the predominant standard for crimp connectors changed to MIL-DTL-22520. During the 1960s, several standards for crimp connectors were published, including MS3191-1, MS3191-4 and MIL-T-22520. In 1953, AMP Incorporated (now TE Connectivity) introduced crimp barrel terminals, and in 1957 Cannon Brothers experimented with machined contacts integrating crimp barrels. The technique of soldering wires has remained common for at least a century, however crimp terminals came into use in the middle of the 20th century. the connectors and wire ends cannot be reused). More specialized crimp connectors are also used, for example as signal connectors on coaxial cables in applications at high radio frequencies ( VHF, UHF) (see below).Ĭrimped contacts are permanent (i.e. If executed properly, the middle of the crimp will be swaged or cold-formed.Ĭlose-up of two ring-tongue terminals before (left) and after (right) crimping. The resulting connection may appear loose at the edges of the terminal, but this is desirable so as to not have sharp edges that could cut the outer strands of the wire. Finally, the handles of the crimp tool are used to compress and reshape the terminal until it is cold-welded onto the wire. The wire is then inserted into the terminal with the end of the wire flush with the exit of the terminal to maximize cross-sectional contact. ![]() The terminal must be placed into the appropriately sized crimp barrel.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |